Ignition Switch - Floor Shift

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Disable the Supplemental Inflatable Restraint (SIR) system.
3. Vehicle wire harness from ignition switch assembly (19).
4. Two tapping screws (20).
5. Ignition switch assembly (19).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parks and systems. Failure to do may result in component damage or malfunction of steering column.

1. Ignition switch assembly (19).
2. Two tapping screws (20).
^ Tighten screws (20) to 1.4 Nm (12 lb in).
3. Vehicle wire harness to ignition switch assembly (19).
4. If all service operations are completed, enable the SIR system.
5. Negative (-) battery cable.