Ignition Lock Cylinder

REMOVE OR DISCONNECT
1. Disable Supplemental Inflatable Restraint (SIR) system.
2. Tilt lever.
3. Upper and lower steering column trim cover.
4. Turn lock cylinder to run position.
5. Push against locking button on back side of bearing and housing assembly and remove lock cylinder.

INSTALL OR CONNECT
1. Lock cylinder to housing assembly.

NOTICE: Rotate the lock cylinder to the "RUN" position. Depress the lock cylinder button. Gently push the lock cylinder into place while rotating the key approximately 5° in the counter-clockwise direction.

2. Upper and lower column cover (3) Torx(R) screws.
3. Tilt lever.
4. Lower left insulator panel (3) screws.
5. Enable SIR system.