Torque Converter Seal Removal

- Tools Required
- J 44103 Torque Converter Seal Remover

1. Insert the three J 44103 puller legs under the Torque Converter Seal (54).
2. Insert the J 44103 support body over the stator shaft (43).
3. Insert the J 44103 puller bridge over the J 44103 support body. Connect the J 44103 puller legs into the slots on the J44103 bridge.

Important: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.

4. Tighten the forcing screw on the J44103 puller bridge until the J 44103 puller legs remove the torque converter seal (54).