Throttle Valve Cable/Linkage: Service and Repair

REMOVE OR DISCONNECT

NOTICE: Observe TV cable routing when removing cable. Duplicate cable routing when installing.





1. TV cable end from accelerator control lever assembly slot.
2. TV cable conduit end from bracket by compressing locking tangs.





3. TV cable routine clips or straps.
4. Bolt securing TV cable to transaxle.
- Pull up on cable cover at transaxle until cable is visible.
5. Cable from transaxle link.
6. Transaxle case seal.

INSTALL OR CONNECT
1. New seal into transaxle case hole.
2. Transaxle end of cable to TV link and secure to transaxle case with bolt and washer assembly.

Tighten
- Bolts to specifications. Refer to "Fastener Tightening Specifications."

3. TV cable routing clips or straps.
4. TV cable conduit end to bracket.
5. TV cable into accelerator control lever assembly slot.

Important
- Avoid damaging or kinking wire cable.

Inspect
- Pull on upper end of cable. It should travel a short distance with light resistance caused by the small return spring on the TV lever. When releasing the upper end of the TV cable it should return to the zero TV position.





Adjust
- TV cable. Refer to "TV Cable Adjustment."