Input Shaft Assembly

^ Tool Required:
- J 33374 Collar Installer
- Or Equivalent

^ Before assembling, apply oil to the thrust surfaces on all gears and washers.

ASSEMBLE
1. Needle bearings and 3rd gear, and install the blocker ring next.

3rd/4th Sleeve/Hub And Collar:

Front Collar Input Shaft:

Rear Bearing Input Shaft:

2. Match the inserts of the 3rd/4th sleeve and hub assembly with the grooves of the blocker ring and press the sleeve and hub assembly and collar using J 33374 and a press. Before installing, apply oil to the collar and hub interiors. After installation, apply oil to the circumference of the collar. Check to ensure the insert springs do not interfere with the hub after installation.
3. Blocker rings and needle bearing, and then the 4th gear and thrust washer. Install the thrust washer with the recessed area facing 4th gear.
4. Collar and stopper plate using J 33374 and a press. Before installing, apply oil to the bearing interior and race surfaces.