Front Wiper Motor

Figure 10:

Figure 11:

Figure 12:

Figure 13:

Figure 14:

Figure 15:

Remove or Disconnect
1. Wiper arm assemblies from wiper transmission assembly drive shaft.
2. Four screws (15), five retainers (16), and air inlet screen assembly (17) from vehicle.
3. Connector (18) from wiper motor assembly (19).
4. Three screws (20) and wiper drive system module (21) from vehicle.
5. Wiper transmission assembly (22) from wiper motor crank arm assembly (23) using tool J 39232.
6. Wiper motor crank arm assembly (23) from wiper motor assembly (19).
A. Loosen screw (24).
B. Tap on screw (24) with a soft-faced mallet while holding up on wiper motor crank arm assembly (23) until wiper motor crank arm assembly (23) is loose on wiper motor assembly (19).
C. Remove screw (24) and wiper motor crank arm assembly (23) from wiper motor assembly (19).
7. Three screws (25) and wiper motor assembly (19) from tube frame (26).

Install or Connect

NOTICE: Refer to Fastener Notice.

1. Wiper motor assembly (19) on tube frame (26) with three screws (25).

Tighten
^ Screws to 7 N.m (62 lb. in.).
2. Wiper motor crank arm assembly (23) on wiper motor assembly (19).
A. Connect connector (18) to wiper motor assembly (19).
B. Put ignition switch in "ACCY" position.
C. Set wiper switch to "PULSE" position. Wiper motor assembly (19) should be operating.
D. Turn off ignition switch while wiper motor is stopped in innerwipe position.
E. Disconnect connector (18) from wiper motor assembly (19).

NOTICE: Do not rotate wiper motor assembly shaft during installation of wiper motor crank arm assembly.

F. Install wiper motor crank arm assembly (23) on wiper motor assembly (19) while maintaining a 4-8 mm (.157 - .315 in.) gap between wiper motor crank arm assembly (23) and bracket tab (F).
G. Install screw (24).
H. Check gap between wiper motor crank arm assembly (23) and bracket tab (F). If gap is not 4-8 mm(.157-.315 in.)remove crank arm assembly (23) and repeat installation step 2.

Tighten
^ Screw to 16 N.m (144 lb. in.).

3. Wiper transmission assembly (22) on wiper motor crank arm assembly (23) using tool J 39529.
4. Wiper drive system module (21) on vehicle with three screws (20).

Tighten
^ Screws to 10 N.m (88 lb. in.).
5. Connector (18) on wiper motor assembly (19).
6. Screen assembly (17) on vehicle with four screws (15) and five retainers (16).
7. Wiper arm assemblies on wiper transmission assembly drive shaft.
8. Operate wipers and check for proper operation.