Fuel Pump Pickup Filter: Service and Repair

REMOVAL PROCEDURE
1. Relieve fuel system pressure.
2. Drain the fuel tank.
3. Remove the fuel tank.
4. Remove the fuel sender assembly.
5. Note the strainer (1) position for future reference.
6. Support the reservoir with one hand and grasp the strainer with the other hand.
7. Use a screwdriver to pry the strainer ferrule off the reservoir.
8. Discard the strainer.

INSTALLATION PROCEDURE
1. Install the new strainer (1) to reservoir.
2. Support the reservoir with one hand and grasp the strainer with the other hand twisting the strainer into position.
3. Install the fuel sender assembly.
4. Install the fuel tank.
5. Refill tank.
6. Install the negative battery cable.
7. Inspect for fuel leaks through the following steps:
7.1. Turn the ignition switch to the ON position for two seconds.
7.2. Turn the ignition switch OFF position for ten seconds.
7.3. Turn the ignition switch to the ON position.
7.4. Check for fuel leaks.