Diagnosis

The PCM calculates an average voltage of each knock sensor's signals and takes instantaneous signal voltage readings. The PCM uses the instantaneous signal voltage readings to determine the state of the knock sensor circuitry. If the knock sensor system is operating normally, the PCM should monitor instantaneous KS signal voltage readings varying outside a voltage range above and below the calculated average voltage. The following DTCs are used to diagnose the knock sensor system:
^ If the PCM malfunctions in a manner which will not allow proper diagnosis of the KS circuits, DTC P0325 will set.
^ DTCs P0327 and P0332 are designed to diagnose the knock sensors, and related wiring, so problems encountered with the KS system should set a DTC. However, if no DTC was set but the KS system is suspect because detonation was the customer's complaint, use the tables for P0327 or P0332 to diagnose the Detonation/Spark Knock Symptom.