Window Run Channel Replacement - Rear Door

REMOVAL PROCEDURE
The rear door stationary window is part of the door window weatherstrip. If the stationary window needs service, replace the entire door window weatherstrip.




1. Place the window in the full down position.
2. Remove the trim panel.
3. Remove the water deflector.
4. Remove the inner energy absorber pad.
5. Remove the rear door inner sealing strip.
6. Remove the stationary window molding.
7. Remove the window weatherstrip bolts.




8. Remove the window weatherstrip from the door.

INSTALLATION PROCEDURE




1. Position the window weatherstrip to the door starting in the corner. Work in both directions.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the window weatherstrip bolts.

Tighten
Tighten the door window weatherstrip bolts to 10 N.m (89 lb in).

3. Close the window.
4. Inspect the glass in order to ensure the window is properly positioned in the window weatherstrip.
5. Install the stationary window molding.
6. Install the rear door inner sealing strip.
7. Install the inner energy absorber pad.
8. Install the water deflector.
9. Install the trim panel.