Blower Motor: Service and Repair

REMOVAL PROCEDURE
The blower motor and fan are located in the lower right corner of the HVAC module. Service this component as an assembly only.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the right sound insulator.
3. Disconnect the electrical connections at the blower motor.
4. Remove the blower motor retaining screws.
5. Remove the blower motor and fan assembly.

INSTALLATION PROCEDURE
1. Install the blower motor and fan assembly.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the retaining screws.

Tighten
Tighten the screws to 5 N.m (45 lb in).

3. Connect the electrical connections.
4. Install the right sound insulator.
5. Connect the negative battery cable.

Tighten
Tighten the negative battery cable bolt to 16 N.m (12 lb ft).