Front Subframe Mount: Service and Repair

Frame Cushion or Insulator Replacement

Tools Required

J 39580 Universal Engine Support Table

Removal Procedure

Important: Perform the procedure exactly as specified, regardless of whether you will replace all of the insulators or only one of the insulators.





Removing any one frame insulator requires loosening the adjacent frame insulators in order to permit the frame to separate from the body.

Use caution when replacing the insulators in order to prevent the following conditions from occurring:

* Breaking the plastic fan shroud
* Damaging the frame attachments (steering hoses, brake pipes)




1. Raise the vehicle using a frame contact hoist. Refer to Vehicle Lifting ().
2. Support the frame (5) near the insulator using J 39580 or suitable jackstands.
3. Remove the bolt and the retainer (4) from the insulator.
4. Remove the lower insulator (3).
5. Raise the body slightly.
6. Remove the following components:

* The upper insulator (2)
* The spacer (1)

Installation Procedure




1. Install the following components:

* The upper insulator (2)
* The spacer (1)

2. Lower the body to the frame (5).
3. Install the lower insulator (3).
4. If the frame insulator bolt does not screw in smoothly, run a tap through the cage in the body in order to remove the foreign material. Ensure that the tap does not punch through the underbody. Position the insulator and the metal washer in order to prevent contact with the frame rail. Do not over tighten the insulator nut. Overtightening the nut may strip the cage nut.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the retainer (4) and the bolt.

Tighten the insulator bolts to 191 N.m (141 lb ft).

6. Test drive the vehicle in order to ensure there are no performance issues.