Cruise Release Switch Replacement

REMOVAL PROCEDURE
1. Remove the left insulator panel.
2. Twist the upper switch (5) counter-clockwise and remove.
3. Disconnect the upper switch electrical connector.

INSTALLATION PROCEDURE

IMPORTANT: When installing the brake pedal switches it is very important that the brake pedal remain in the full up or at rest position or damage to the brake system and/or switch misadjustment may occur.

1. Connect the upper switch (5) electrical connector.
2. Install the upper switch (5) into the upper retainer. Face the switch connector to the 6 o'clock position.

IMPORTANT: The release switch assembly and the stoplamp switch assembly cannot be adjusted until after the brake booster pushrod is assembled to brake pedal assembly. Incorrect adjustment could cause the cruise control system to not work properly.

3. Adjust the switch.
4. Install the left insulator panel.