89. Supercharger Installation

1. Install the supercharger gasket.





2. Install the supercharger.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the spacers, bolts, and stud to the supercharger in the proper locations.
- Tighten the stud/bolts to 23 Nm (17 ft. lbs.).





4. Install the TBI and gasket.
5. Install the TBI nuts.
- Tighten the TBI nuts to 10 Nm (89 inch lbs.).





6. Install the engine wiring harness heat shield.
7. Install the engine wiring harness heat shield bolt and nut
- Tighten the engine wiring harness heat shield bolt and nut to 10 Nm (89 inch lbs.).





8. Install the MAP sensor bracket.
9. Install the MAP sensor bracket bolts.
- Tighten the MAP sensor bracket bolts to 30 Nm (22 ft. lbs.).
10. Install the vacuum block.
11. Install the vacuum block bolts.
- Tighten the vacuum block bolts to 10 Nm (89 inch lbs.).
12. Install the boost solenoid.
13. Install the boost solenoid bolts.
- Tighten the boost solenoid bolts to 26 Nm (19 ft. lbs.).
14. Install the regulator valve and harness bolt.





15. Install the booster bypass.
16. Install the booster bypass nut.
- Tighten the booster bypass nut to 10 Nm (89 inch lbs.).





17. Install the fuel rail.
18. Install the fuel rail nuts and stud.
- Tighten the fuel rail nuts and stud to 10 Nm (89 inch lbs.).
19. Install the vacuum line to the fuel rail.

Water Pump Installation
- Tools Required
- J 36660-A Torque Angle Meter





1. Install the water pump gasket.
2. Install the water pump.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the water pump bolts.
- Tighten the water pump bolts to 15 Nm (11 ft. lbs.). Use J 36660-A to tighten the bolt an additional 80 degrees.





4. Install the water pump pulley.
5. Install the water pump pulley bolts.
- Tighten the water pump pulley bolts to 13 Nm (1116 inch lbs.).