Closeout/Insulator Panel Replacement - Left

REMOVAL PROCEDURE




1. Remove the fasteners at the rear edge of the insulator to disengage from the lower instrument panel.
2. Pry out the retainers to release.




3. Turn the heater temperature sensor 1/4 turn to release and allow to remain connected to its wire (CJ2 vehicles only).
4. Disconnect the remaining electrical connectors as necessary.

INSTALLATION PROCEDURE




1. Position and turn 1/4 turn to install the heater temperature sensor (CJ2 vehicles only).
2. Connect the remaining electrical connectors.




3. Set the forward edge of the insulator onto the shelf of the dash mat.

IMPORTANT: Correct installation is necessary for the correct heater air distribution.

4. Align the insulator to the floor duct at the heating, ventilation and air conditioning module.
5. Align the snap tab fasteners to the lower instrument panel and push upward to engage.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the fasteners into the lower instrument panel.

Tighten
Tighten the fasteners to 2 N.m (18 lb in).

For a description of the RPO Code(s) shown in this article refer to the RPO Code List found at Vehicle/Application ID RPO Codes