Knock Sensors

The knock sensors detect the abnormal vibration of spark knocking in the engine. The sensors are mounted in the engine block near the cylinders. The knock sensors produce an AC voltage signal under all engine operating conditions. The PCM adjusts the Ignition Control (IC) spark timing based on the amplitude and frequency of the KS signal being received.

The PCM contains integrated Knock Sensor (KS) diagnostic circuitry. The PCM uses the circuitry to diagnose the KS sensors and the related wiring. During normal operation the PCM calculates the average voltage of each knock sensor signal. If the knock sensor system is operating normally, the PCM should monitor KS signal voltages varying over 0.5 volt more than and less than the calculated average voltage. If the PCM malfunctions in a manner which will not allow proper diagnosis of the KS circuit, DTC P0325 will set.

DTCs P0327 and P0332 are designed to diagnose the knock sensors, and related wiring, so problems encountered with the KS system should set a DTC.

Refer to Knock Sensor (KS) System Description for a complete description of the knock sensor system.