Fuel Pump Control Unit: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Pull back the rear compartment trim panel (1).




3. Remove the fuel pump control module attaching nut (3).
4. Remove the electrical connector (2) from the fuel pump control module (1).

INSTALLATION PROCEDURE




1. Install the fuel pump control module (1).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the attaching nut (3) to the fuel pump control module (1).

Tighten
Tighten the nut to 9 N.m (80 lb in).

3. Connect the electrical connector (2) to the fuel pump control module.




4. Install the trunk liner (1).
5. Connect the negative battery cable.




6. Install the rear seat cushion.