Inflatable Restraint Sensing and Diagnostic Module (AS1)

CAUTION:
^ Be careful when you handle a Sensing and Diagnostic Module (SDM). Do not strike or jolt the SDM. Before applying power to the SDM:
^ Remove any dirt, grease, etc. from the mounting surface
^ Position the SDM horizontally on the mounting surface
^ Point the arrow on the SDM toward the front of the vehicle
^ Tighten all of the SDM fasteners and SDM bracket fasteners to the specified torque value

Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.

CAUTION: If any water enters the vehicle's interior up to the level of the carpet or higher and soaks the carpet, the Sensing and Diagnostic Module (SDM) and the SDM harness connector may need to be replaced. The SDM could be activated when powered, which could cause deployment of the air bag(s) and result in personal injury. Before attempting these procedures, the SIR system must be disabled. Refer to Disabling the SIR System.

With the ignition OFF, inspect the SDM mounting area, including the carpet. If any significant soaking or evidence of significant soaking is detected, you must perform the following tasks:
1. Remove all water.
2. Repair the water damage.
3. Replace the SDM harness connector.
4. Replace the SDM.

Failure to follow these tasks could result in possible air bag deployment, personal injury, or otherwise unneeded SIR system repairs.

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to Disabling the SIR System.
2. Move both driver and passenger seat forward and/or to the rear to gain access to console fasteners.
3. Remove the console.
4. When the console is remove the carpet will be pre-slit to provide access to the inflatable restraint Sensing and Diagnostic Module (SDM).




5. Remove the Connector Position Assurance (CPA) (1) from the inflatable restraint Sensing and Diagnostic Module (SDM) wiring harness connector (2).
6. Push down flex lock button (3) and then move sliding connector locking cover (4) to the open position.




7. Remove push-on clip (1) securing SDM wiring harness to console stud.
8. Disconnect the SDM wiring harness connector (3) from the SDM (2).




9. Remove the SDM mounting fasteners (1).
10. Remove the SDM (2) from the console floor (3).

INSTALLATION PROCEDURE




1. Install the SDM (2) to console floor (3).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the SDM mounting fasteners (1).

Tighten
Tighten fasteners to 9 N.m (80 lb in).




3. Connect the SDM wiring harness connector (3) to the SDM (2).
4. Install push-on clip (1) securing SDM wiring harness to console stud.




5. Push down flex lock button (3) and then move sliding connector locking cover (4) to the close position.
6. Install the Connector Position Assurance (CPA) (1) to the inflatable restraint Sensing and Diagnostic Module (SDM) wiring harness connector (2).




7. Install the carpet pre-slit to the close position covering the inflatable restraint Sensing and Diagnostic Module (SDM).
8. Install the console.
9. Install the driver and passenger seat to the original position.
10. Enable the SIR system. Refer to Enabling the SIR System.
11. After replacing the SDM the new SDM must be programmed into the Dash Integration Module. Refer to BCM Programming/RPO Configuration in Body Control Systems.