Tilt Head Housing - Assemble

Assembly Procedure

- Tools Required
- J23653-SIR Lock Plate Compressor





1. Install the inner race (4).
2. Install the upper bearing inner race seat (3).
3. Install the upper bearing spring (2).
4. Lubricate the turn signal cancel cam assembly (1).

Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the turn signal cancel cam assembly.

5. Install the turn signal cancel cam assembly (1).





6. Install the shaft lock shield assembly.





7. Install the new bearing retainer using J23653-SIR.
8. Remove J23653-SIR from the steering shaft assembly.
9. Install the SIR coil assembly. Refer to Inflatable Restraint Steering Wheel Module Coil - Assemble - Off Vehicle.