P1336

Engine Controls Schematics: Ignition Control Inputs:

CIRCUIT DESCRIPTION

The Crankshaft Position (CKP) system variation learning feature is used to calculate reference period errors caused by slight tolerance variations in the crankshaft, the crankshaft balancer interrupter rings, and the crankshaft position sensor hall effect switches. The calculated error allows the Powertrain Control Module (PCM) to accurately compensate for reference period variations. This enhances the ability of the PCM to detect misfire events over a wider range of engine speed and load.

The crankshaft position system variation values are stored in the PCM non-volatile memory after a learn procedure has been performed. A DTC P1336 set indicates that the crankshaft position system variation values have not been stored in the PCM and the crankshaft position system variation learn procedure must be performed. The learn procedure is required after the following service procedures have been performed, regardless of whether or not DTC P1336 is set:
^ A PCM replacement
^ An engine replacement
^ A crankshaft replacement
^ A crankshaft balancer replacement
^ A crankshaft position sensor replacement
^ Any engine repair which disturb the crankshaft/harmonic balancer to crankshaft position sensor relationship.

CONDITIONS FOR RUNNING THE DTC
^ No CMP or CKP sensor DTC(s) set.
^ Engine Coolant Temperature is greater than 70°C (158°F).

CONDITIONS FOR SETTING THE DTC
The crankshaft position system variation values are not stored in the PCM memory.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will illuminate the Malfunction Indicator Lamp (MIL) during the first trip in which the diagnostic test has been run and failed.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame and Failure Records data.

Diagnostic Chart:

CONDITIONS FOR CLEARING THE MIL/DTC
^ The PCM will turn OFF the MIL during the third consecutive trip in which the diagnostic has been run and passed.
^ The History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

DIAGNOSTIC AIDS
If the crankshaft position system variation learn procedure cannot be performed successfully, check for the following conditions and correct as necessary:
^ An engine coolant temperature below 70°C (158°F). Allow the engine to warm to more than 70°C (158°F).
^ Any powertrain DTCs set. The scan tool crankshaft position system variation learn function will be disabled if any powertrain DTCs other than DTC P1336 are stored.
^ A camshaft position signal problem detected. Refer to DTC P0336 Crankshaft Position (CKP) Sensor Circuit P0336
^ A 3X reference signal problem detected. Refer to DTC P1374 Crankshaft Position (CKP) High to Low Resolution Frequency Correlation. P1374
^ An 18X reference signal problem detected. Refer to DTC P0341 Camshaft Position (CMP) Sensor Performance. P0341