P0500
Schematic:
CIRCUIT DESCRIPTION
Vehicle speed information is provided to the PCM by the Vehicle Speed Sensor (VSS). The VSS consists of a magnetic pickup sensor mounted to the transmission case which interfaces with a rotor pressed onto to the transmission output shaft. The VSS produces a frequency signal that is proportional to vehicle speed. The PCM converts the VSS signal to vehicle speed, displayed on the scan tool in miles per hour and kilometers per hour. The PCM also uses the VSS signal to generate the 4000 pulses per mile vehicle speed signal used by the instrument cluster and the TAC module.
CONDITIONS FOR RUNNING THE DTC
^ Engine speed is more than 1250 RPM.
^ Engine load and engine speed acceleration indicate that the vehicle is in gear.
CONDITIONS FOR SETTING THE DTC
Vehicle speed sensor indicates a speed of less than 5 km/h (3 MPH) for more than 20 seconds.
ACTION TAKEN WHEN THE DTC SETS
^ The PCM will illuminate the Malfunction Indicator Lamp (MIL) during the second consecutive trip in which the diagnostic has been run and failed.
^ If equipped with traction control, the PCM will command the Electronic Brake And Traction Control Module (EBTCM) via the serial data circuit to turn OFF traction control, and the EBTCM will illuminate the TRACTION OFF lamp.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame and Failure Records data.
CONDITIONS FOR CLEARING THE MIL/DTC
^ The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.
^ The History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.
DIAGNOSTIC AIDS
Inspect for the following:
Inspect for a Loose or damaged VSS rotor - A damaged VSS rotor may cause an erratic or incorrect vehicle speed to be displayed. Refer to Manual Transmission section for on-vehicle service.
IMPORTANT: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.
^ Poor terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Use a corresponding mating terminal to test for proper tension. Refer to Testing for Intermittent and Poor Connections and Connector Repairs in Diagrams.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness appears to be OK, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the display may indicate the location of the fault. Refer to Wiring Repairs in Diagrams.
^ Inspect the PCM and the engine grounds for clean and secure connections.
If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.
TEST DESCRIPTION
Diagnostic Chart:
The numbers below refer to the step numbers on the diagnostic table:
2. If the condition that caused the DTC to set cannot be duplicated, inspect the Items referred to in Diagnostic Aids may isolate the cause of an intermittent fault.