Operation CHARM: Car repair manuals for everyone.

P1514

CIRCUIT DESCRIPTION
The PCM uses the TP, BARO, IAT and engine RPM in order to calculate an expected mass airflow rate. The PCM compares this value to the mass airflow value and the speed density calculation in order to verify the proper throttle operation.

CONDITIONS FOR RUNNING THE DTC
^ No other ETC DTCs are present.
^ No PCM processor DTCs are present.
^ Engine is running and engine speed is more than 600 RPM.

CONDITIONS FOR SETTING THE DTC
The PCM detects that the actual Airflow (MAF) and Speed Density is much more than the expected (calculated) airflow rate.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM will illuminate the MIL during the first trip in which the diagnostic runs and fails.
^ If equipped with traction control, the PCM will command the EBTCM via the serial data circuit to turn OFF traction control and illuminate the TRACTION OFF lamp.
^ The PCM will store conditions which were present when the DTC set as Freeze Frame/Failure Records data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The PCM will turn the MIL OFF during the third consecutive trip in which the diagnostic has been run and passed.
^ The History DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using a scan tool.

DIAGNOSTIC AIDS
Inspect for the following:
^ Inspect the throttle blade for being broken, bent, or missing.
^ Skewed cam sensor Signal - Intermittently shorted to ground, causing a fluctuating RPM as seen on the scan tool.

IMPORTANT: Remove any debris from the connector surfaces before servicing a component. Inspect the connector gaskets when diagnosing or replacing a component. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion.

^ Poor terminal connection.
Inspect the harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and faulty terminal to wire connection. Use a corresponding mating terminal to test for proper tension. Refer to Testing for Intermittent and Poor Connections and Connector Repairs in Diagrams.
^ Damaged harness.
Inspect the wiring harness for damage. If the harness appears to be OK, observe the display on the scan tool while moving connectors and wiring harnesses related to the sensor. A change in the display may indicate the location of the fault. Refer to Wiring Repairs in Diagrams.
^ Inspect the PCM and the engine grounds for clean and secure connections.

If the DTC is determined to be intermittent, reviewing the Failure Records can be useful in determining when the DTC was last set.

TEST DESCRIPTION

Diagnostic Chart:





The numbers below refer to the step numbers on the diagnostic table.
3. Physically/visually inspect the throttle body assembly and correct any problems that you observe. Manually move the throttle blade from closed to Wide Open Throttle (WOT). You should not need to use excessive force. The throttle blade should move smoothly through the full range and should return to a slightly open position on its own.
5. When the PCM detects a problem within the ETC System other DTCs may set due to the many redundant tests run continuously on this system. Locating and repairing one individual problem may correct more than one DTC. keep this in mind when reviewing captured DTC info.