Operation CHARM: Car repair manuals for everyone.

Front Floor Console Replacement



Front Floor Console Replacement

Removal Procedure

1. Suitably block the drive wheels.




2. Turn the ignition key to the RUN (4) position.
3. Place the shift lever in the NEUTRAL position.
4. Remove the console trim plate.




5. Raise the park brake handle as far as possible.
If the park brake handle cannot be pulled up far enough to remove the console, perform the following steps:

* Release the park brake handle.
* Hold the adjuster pawl disengaged.
The park brake handle can be pulled up further.




6. Remove the floor console bolts (1).
7. Disconnect the power outlet electrical connector.
8. Remove the floor console (2) from the vehicle.

Installation Procedure




1. Install the floor console (2) to the vehicle.
2. Connect the power outlet electrical connector.
3. Release the park brake handle.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the floor console bolts (1).

Tighten the to 8 N.m (71 lb in).

5. Install the console trim plate.
6. Place the shift lever in the PARK position.
7. Turn the ignition key to the OFF position (2).