Rear Compartment Lid Release

AUTOMATIC TRANSMISSION
Voltage is applied at all times from the PWR ACCY fuse through circuit 640 to the normally open contacts of the rear compartment lid release relay. When the rear compartment lid release button on the remote control door lock transmitter is pressed twice, voltage is applied from the body control module (BCM) through circuit 253 to the coil of the rear compartment lid release relay. If the transmission is in the PARK or NEUTRAL position, the relay is energized. The relay then applies battery voltage through circuit 56 to the rear compartment lid release actuator. Ground is applied from G400 through circuit 1550 to the actuator. The rear compartment lid opens.

MANUAL TRANSMISSION
Voltage is applied at all times from the PWR ACCY fuse through circuit 640 to the normally open contacts of the rear compartment lid release relay. When the rear compartment lid release button on the remote control door lock transmitter is pressed twice, voltage is applied from the body control module (BCM) through circuit 253 to the coil of the rear compartment lid release relay. If the park brake is set, the park brake switch is closed and the relay is energized. The relay then applies battery voltage through circuit 56 to the rear compartment lid release actuator. Ground is applied from G400 through circuit 1550 to the actuator. The rear compartment lid opens.

ILLUMINATED ENTRY OPERATION
The dome lamp (coupe) or the rear courtesy lamps illuminate whenever a remote control door lock transmitter unlock request is received by the body control module (BCM). The BCM provides voltage through circuit 149 to the dome lamp (coupe) or the rear courtesy lamps (convertible). Ground is applied from the BCM through circuit 156 to the lamps. The lamps illuminate whenever a remote control door lock transmitter request is received.

With a LOCK request, the dome lamp (coupe) or the rear courtesy lamps (convertible) are immediately turned off. This action provides visual confirmation that a lock function was performed.

With an unlock or a rear compartment lid release request, the dome lamp (coupe) or the rear courtesy lamps (convertible) are turned on. The lights remain on for 40 seconds in order to provide illuminated entry and hatch area illumination.

Illuminated entry is disabled when the BCM detects ignition ON voltage.

PROGRAMMING THE BODY CONTROL MODULE
The body control module (BCM) is capable of being programmed for up to four keyless entry transmitters. When four transmitters are programmed, they must be programmed one after the other during the same program sequence. Transmitters may not be programmed simultaneously. The BCM can only be programmed by the transmitters while in the program mode.