Lock Striker Adjustment - Door
TOOLS REQUIREDJ 39346-A Mini-Wedge Door striker Aligner
1. Loosen door lock striker bolts/screws (1) just enough to allow movement of the lock striker (2).
IMPORTANT: Door must be properly aligned before adjusting the striker.
2. Install J 39346-A to the lock striker (2).
3. Close the door while holding the outside handle in the open position.
IMPORTANT: Do not slam door.
4. Open the door.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Retighten the lock striker bolts.
Tighten
Tighten the door lock striker bolts/screws (1) to 29 N.m (21 lb ft).
6. Remove J 39346-A.