Blower Motor: Service and Repair
BLOWER MOTOR AND FAN REPLACEMENTREMOVAL PROCEDURE
1. Remove the key from the ignition switch in order to ensure that the ignition switch will remain OFF.
2. Remove the right instrument panel insulator.
3. Disconnect the blower motor electrical connector.
4. Remove the blower motor bolts (2).
5. Remove the blower motor (3).
6. Inspect the blower motor terminals for corrosion. Perform the following tasks as necessary:
^ Clean the corrosion from the terminals.
^ Replace the blower motor.
7. Inspect the flange of the blower motor for any damage or distortion which could cause an air leak.
Repair the flange of the blower motor as necessary.
8. Inspect the blower motor fan for damage and distortion.
Perform the following tasks as necessary:
^ Repair the blower motor fan.
^ Replace the blower motor fan.
INSTALLATION PROCEDURE
1. Install the blower motor (3) using the following steps:
1.1. Guide the blower motor (3) into position. Do not catch the blower motor fan on the protruding parts.
NOTE: Refer to Fastener Notice in Service Precautions.
1.2. Install the blower motor bolts (2).
Tighten
Tighten the blower motor bolts (2) to 2.3 N.m (20 lb in).
2. Connect the blower motor electrical connector.
3. Install the right instrument panel insulator.
4. Check the blower for proper operation.