V7 - Direct Mount

TOOLS REQUIRED
^ J 8433 Compressor Pulley Puller
^ J 8433-3 Forcing Screw
^ J 33023-A Puller Pilot
^ J 33025 Clutch Coil Puller Legs
^ J 41790 Compressor Holding Fixture




1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J 41790 in a vise and attach the compressor to the J 41790.




3. Remove the compressor clutch plate and hub assembly.
4. Install the J 33023-A onto the front head of the compressor.
5. Remove the compressor rotor and bearing assembly. Refer to Clutch Rotor and/or Bearing Removal (V7 - Direct Mount).




6. Mark the clutch coil terminal location (2) on the compressor front head.
7. Install the J 33025 onto the J 8433.
8. Install the J 8433 onto the compressor clutch coil (1) and tighten the puller leg bolts.
9. Tighten the center forcing screw J 8433-3 of the compressor pulley puller J 8433 against the J 33023-A to remove the compressor clutch coil from the compressor.
10. Remove the J 8433-3, the J 33023-A, the J 33025 and the J 8433.