Ignition Coil: Service and Repair
REMOVAL PROCEDURE1. Disconnect the electrical connector from the control module.
2. Disconnect the spark plug wires from the coil being serviced.
3. Remove the ignition coil bolts (2).
4. Remove the ignition coil (1) from the module (4).
5. Remove the ignition coil seal (3), if required.
INSTALLATION PROCEDURE
1. Install the ignition coil seal (3), if removed.
2. Install the ignition coil (1) to the module (4).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the ignition coil bolts (2).
Tighten
Tighten the ignition coil bolts (2) to 4 N.m (35 lb in).
4. Connect the spark plug wires to the coil.
5. Connect the electrical connector from the control module.
Tighten
Tighten the ignition control module bolt to 2.5 N.m (22 lb in).