Gear Lockout Solenoid: Service and Repair

Removal Procedure

^ Tools Required
- J 41099 Gear Select/Reverse Lockout Solenoid Socket





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the reverse lockout solenoid electrical connector (2).
3. Place a drain pan under the transmission in case any fluid drips out.





4. Remove the reverse lockout solenoid using J 41099.
5. Remove the reverse lockout assembly bolt.
6. Remove the reverse lockout assembly, if necessary.


Installation Procedure

^ Tools Required
- J 41099 Gear Select/Reverse Lockout Solenoid Socket





1. Install the reverse lockout assembly, if necessary.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the reverse lockout assembly bolt.
^ Tighten the reverse lockout assembly bolt to 18 Nm (13 ft. lbs.).
3. Install the reverse lockout solenoid using the J 41099.
^ Tighten the reverse lockout solenoid to 40 Nm (30 ft. lbs.).
4. Remove the drain pan.





5. Connect the reverse lockout solenoid electrical connector (2).
6. Check the transmission fluid level.
7. Lower the vehicle.