Starter Heat Shield: Service and Repair

REMOVAL PROCEDURE
1. Raise and suitably support the vehicle.






2. Remove the starter motor shield bolts (1 and 3) and nut (2).
3. Remove the starter motor shield from the vehicle.

INSTALLATION PROCEDURE
1. Install the starter motor shield to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the starter shield nut (2) and bolts (1 and 3).

Tighten
^ Tighten to starter motor shield bolt (1) to 30 N.m (22 lb ft).
^ Tighten the starter motor shield bolt (3) to 10 N.m (89 lb in).
^ Tighten the starter motor shield nut (2) to 10 N.m (89 lb in).

3. Lower the vehicle.