SIR Steering Wheel Module Coil - Disassemble

Disassembly Procedure

- Tools Required
- J41352 Modular Column Holding Fixture





1. Set the steering column and J41352 into a vise.

Important: Align the block tooth on the race and upper shaft assembly to the 12 o'clock position. Remove only those components necessary to do the repairs.

2. Check the steering column jacket assembly for any accident damage. Refer to Steering Column Accident Damage Inspection-Off Vehicle.
3. Place the ignition in the "LOCK" position to center the coil assembly.
4. Remove the wire harness assembly strap (1).





5. Remove the retaining ring from the steering shaft assembly.





6. Remove the wire harness straps and the wire protector from the steering column.
7. Disconnect the SIR coil assembly connector at the base of the steering column, if needed.
8. Remove the SIR coil assembly from the steering shaft assembly.
9. Attach mechanics wire to the SIR coil assembly connectors for reassembly.
10. Pull the SIR coil assembly connectors through the steering column, if needed.