Seals and Gaskets: Service and Repair

Removal Procedure

^ Tools Required
- J 23907 Slide Hammer
- J 26941 Extension Housing Seal Remover





1. Remove the propeller shaft.
2. Remove the output shaft seal using J 23907 and J 2694 1.


Installation Procedure

^ Tools Required
- J 21426 Extension Housing Seal Installer





1. Install the output shaft seal using J21426.





2. Lubricate the inside diameter of the seal. Use Dexron III automatic transmission fluid or equivalent.
3. Install the propeller shaft.
4. Check the transmission fluid level.