Convertible

REMOVAL PROCEDURE
1. Remove the right side compartment trim.
2. Drill out the rivet from the bracket.
3. Remove the amplifier bolt.
4. Lift the amplifier up in order to disengage the clips from the wheelhouse flange.
5. Disconnect the amplifier electrical connector.
6. Remove the amplifier from the vehicle.

INSTALLATION PROCEDURE
1. Install the amplifier to the vehicle.
2. Connect the amplifier electrical connector.
3. Place tabs on the amplifier over the rear wheelhouse flange.
4. Position the amplifier bracket leg onto the inboard side of the support panel frame.
5. Install the amplifier bolt.
6. Install the rivet through the hole in the amplifier bracket and through the support.
7. Install the right side compartment trim.