Radio Replacement

REMOVAL PROCEDURE




1. Unsnap the instrument panel (IP) accessory trim plate.




2. Remove the radio bracket bolts (1).
3. Slide the radio (2) out from the IP.




4. Remove the following components from the radio (4):
^ The IP wiring harness connector (1)
^ The remote CD connector (2)
^ The antenna cable (3)
5. Remove the radio (4) from the vehicle.

INSTALLATION PROCEDURE




1. Install the radio (4) to the vehicle.
2. Install the following components to the radio (4):
^ The antenna cable (3)
^ The remote CD connector (2)
^ The IP wiring harness connector (1)




3. Slide the radio (2) into the IP.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the radio bracket bolts (1) in the following sequence:
4.1. Lower left
4.2. Upper right
4.3. Upper left

Tighten
Tighten the radio bracket bolts (1) to 1.8 N.m (16 lb in).




5. Install the IP accessory trim plate.
6. Disable the radio Theftlock(R) feature.