Mirror Face Replacement (Electric Adjust)

REMOVAL PROCEDURE

CAUTION: When working with any type of glass, use approved safety glasses and gloves to reduce the chance of personal injury.

1. Push in on one edge of the mirror glass (1) tilting the mirror case to allow finger access.
2. Grasp the glass (1) case firmly and pull the case from the mirror body.

IMPORTANT: Inspect the motor pack unit (5) and if damaged, replace entire mirror assembly.

3. Remove the jackscrews (4) from the motor pack unit (5).

INSTALLATION PROCEDURE

CAUTION: When working with any type of glass, use approved safety glasses and gloves to reduce the chance of personal injury.

1. Install the jackscrews (4) and trunion bars (2) to the new glass (1).
2. Install new rearview mirror glass.
2.1. Align jackscrews (3) perpendicular to the glass (1).
2.2. Align trunnion bar parallel (2) to glass
2.3. Position end of jackscrews (3) at opening approximately 13 mm (0.5 inch) into pack unit (5).
2.4. Visually align trunnion bar with receptor by lifting inboard corner of glass.
2.5. Apply pressure with palm of hand until glass is seated firmly to receptor.
2.6. Manually rotate glass to check for proper installation.