Front Seat Replacement - Bucket (Manual)

Front Seat Replacement - Bucket (Manual)

Removal Procedure




1. Place a protective tape over the nearby trim and paint.
2. Remove the caps (3) from seat adjuster nuts (4).
3. Remove the seat adjuster nuts (4) from the studs (2, 5).
4. Disconnect the seat belt wiring harness electrical connector, as required.
5. Remove the front bucket seat (1) from the vehicle.

Installation Procedure




1. Install the front bucket seat (1) on to the studs (2, 5) in the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the seat adjuster nuts (4) to the studs (2, 5).

Tighten the seat adjuster nuts to 50 N.m (37 lb ft).

3. Connect the seat belt wiring harness electrical connector, if required.
4. Install the caps (3) to the nuts (4).
5. Remove the protective tape from the nearby trim and paint.