With Traction Control, Electronic

REMOVAL PROCEDURE




1. Unsnap and remove the cruise control servo cable adjuster cover.




2. Rotate the upper cam, and remove the cruise control cable slug from the servo cable adjuster.
3. Unsnap the locking tab and remove the cable from the slot.




4. Unsnap the cruise control cable (1) from the accelerator control cable clip (3).
5. Remove the cruise control cable from under the accelerator/cruise control cable servo bracket.




6. Remove the cruise control cable clip from the brake booster.
7. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
8. Remove the left front bumper fascia lower deflector.




9. Disconnect the cruise control cable rosebud clip from the brake pipe clip.




10. Remove the cruise control module shield bolts and nut.
11. Remove the cruise control shield.




12. Unsnap and remove the cruise control module cover.




13. Remove the cable locking retainer from the module.
Compress the conduit tangs




14. Pull the cruise control cable (4) out from the module (2).
15. Unhook the cable bead (1) from the module ribbon (3)
16. Remove the cruise control cable from the vehicle.

INSTALLATION PROCEDURE




1. Install the cruise control cable to the vehicle.
2. Inspect the cable end to insure the 0-ring is in place.
3. Hook the cable bead (1) to the module ribbon (3)
4. Remove the shipping retainer.
5. Rotate the cable end if necessary, to straighten the ribbon.
6. Pull the throttle body end of the cable until the cable is taut.
7. Push the cable fitting end over the ribbon.




8. Snap the cable end into the module.
9. Ensure that the conduit tangs are engaged.
10. Install the cable locking retainer to the module.




11. Align the cruise control module cover over the cable and bracket.




12. Snap the cover closed over the flanges on the bracket.




13. Install the cruise control module shied.

NOTE: Refer to Fastener Notice in Service Precautions.

14. Install the cruise control module shield bolts and nut.

Tighten
^ Tighten the cruise control module shield bolts to 6 N.m (53 lb in).
^ Tighten the cruise control module shield nut to 27 N.m (20 lb ft).




15. Connect the cruise control cable rosebud clip to the brake pipe clip.
16. Install the left front bumper fascia lower deflector.
17. Lower the vehicle.




18. Install the cruise control cable clip to the brake booster.
19. Install the cruise control cable under the accelerator/cruise control cable servo bracket.




20. Snap the cruise control cable (1) into the accelerator control cable clip (3).




21. Rotate the upper cam, and install the cruise control cable slug to the servo cable adjuster.
22. Slide the cable onto the slot, ensure locking tab is snapped into position.




23. Slide the cruise control servo cable adjuster cover down and snap into place.
24. Adjust the cruise control cable as needed. Refer to Cruise Control Cable Adjustment (With RPO Traction Control, Electronic).