Cylinder Head Replacement - Left

Removal Procedure





1. Remove the engine coolant air bleed pipe. Refer to Vapor Vent Pipe Replacement.
2. Remove the power steering pump rear bracket. Refer to Power Steering Pump Rear Bracket Replacement in Steering and Suspension.
3. Remove the left side exhaust manifold. Refer to Exhaust Manifold Replacement (Left).
4. Remove the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement.
5. Remove the harness ground bolts (2 and 3) from the rear of the cylinder head.





6. Remove the left-side cylinder head. Service and Repair

Installation Procedure





1. Install the left side cylinder head. Service and Repair

Notice: Refer to Fastener Notice in Service Precautions.





2. Install the harness ground bolts to the cylinder head.
- Tighten the harness ground bolts (2 and 3) to 50 Nm (37 ft. lbs.).
4. Install the valve rocker arms and pushrods. Refer to Valve Rocker Arm and Push Rod Replacement.
4. Install the left side exhaust manifold. Refer to Exhaust Manifold Replacement (Left).
5. Install the power steering pump rear bracket. Refer to Power Steering Pump Rear Bracket Replacement in Steering and Suspension.
6. Install the engine coolant air bleed pipe. Refer to Vapor Vent Pipe Replacement.