Trans AM

REMOVAL PROCEDURE




1. Raise and suitably support the vehicle.
2. Remove the push pin retainers that are located at the bottom center of the front fascia.
3. Disconnect the electrical connector from the fog lamp.




4. Remove the fog lamp bolts.
5. Remove the fog lamp and bracket.

INSTALLATION PROCEDURE




1. Install the fog lamp and bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the fog lamp bolts.

Tighten
Tighten the fog lamp bolt to 15 N.m (11 lb ft).




3. Connect the electrical connector to the fog lamp.
4. Install the push pin retainers at the bottom center of the front fascia.
5. Lower the vehicle.