Removal and Replacement

REMOVAL PROCEDURE




1. Turn the ignition key to the RUN position (4).
2. Turn the headlamps ON, then turn the switch back to park lamps.
This will leave the headlamps in the up position with the lamps off.
3. Turn the ignition key to the OFF position (1).




4. Open the hood.
5. Remove the headlamp bezel screws.
6. Remove the headlamp bezel.




7. Remove the headlamp screws that attach the A mounting ring to the headlamp housing.
8. Remove the headlamp mounting ring.
9. Disconnect the electrical connector from the headlamp.




10. Remove the headlamp.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the headlamp.
2. Install the headlamp.





3. Install the headlamp mounting ring.
4. Install the headlamp screws that attach the mounting ring to the headlamp housing.





5. Install the headlamp bezel.

NOTE: Refer to Fastener Notice in Service Precautions.

6. Install the headlamp bezel screws.

Tighten
Tighten the headlamp bezel screws to 1.7 N.m (15 lb in).

7. Close the hood.
8. Turn the headlamp switch off.