General Description

Voltage is applied when the ignition is in the RUN position through the TURN B/U Fuse 2 to the [1][2]turn signal lamp flasher through circuit 141.Voltage is then applied from the flasher to the turn/hazard switch assembly through the turn signal flasher output circuit. When the turn signal switch is placed in the left turn position, voltage is applied through the closed contacts of the turn signal switch to the left tail/stop/turn lamp through the left rear stop/turn lamp feed circuit (Europe) or through the left front turn signal lamp feed circuit (Japan). When the turn signal switch is placed in the right turn position, voltage is applied through the closed contacts of the turn signal switch to the right tail/stop/turn lamp through the right rear stop/turn lamp feed circuit (Europe) or the right front turn signal lamp feed circuit (Japan).