PCM Replacement/Programming

Service of the PCM should normally consist of either replacement of the PCM or EEPROM programming. If the diagnostic procedures call for the PCM to be replaced, the PCM should be checked first to see if it is the correct part. If it is, remove the faulty PCM and install the new service PCM.

THE SERVICE PCM EEPROM WILL NOT BE PROGRAMMED. DTC P0601 and P0602 indicates the EEPROM is not programmed or has malfunctioned.

IMPORTANT: The following must be performed anytime the PCM is replaced:
1. Program the PCM.
2. The Idle Learn Procedure.
3. The CKP System Variation Learn Procedure.
4. The Engine Oil Life Reset Procedure.
5. The Functional Check.

The following must be performed anytime the PCM is disconnected, reprogrammed or loses power:
1. The Idle Learn Procedure
2. The Functional Check

NOTE: Turn the ignition OFF when installing or removing the PCM connectors and disconnecting or reconnecting the power to the PCM (battery cable, PCM pigtail, PCM fuse, jumper cables, etc.) in order to prevent internal PCM damage.

IMPORTANT: Ensure that the hood is free of contaminates (moisture) before servicing the PCM. The moisture flows into the PCM connector body when the PCM is disconnected and the hood is opened.

REMOVAL PROCEDURE

IMPORTANT: Remove any debris from the PCM connector surfaces before servicing the PCM. Inspect the PCM module connector gaskets when diagnosing/replacing the PCM. Ensure that the gaskets are installed correctly. The gaskets prevent contaminate intrusion into the PCM.




1. Disconnect the negative battery cable.

NOTE:
^ Do not touch the connector pins or soldered components on the circuit board in order to prevent possible Electrostatic Discharge (ESD) damage to the PCM.
^ In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.

2. Disconnect the PCM connectors.




3. Remove the mounting fasteners from the PCM bracket.




4. Remove the PCM and mounting bracket assembly from the engine compartment.
5. Remove the PCM (1) from the mounting bracket (2).

INSTALLATION PROCEDURE

NOTE:
^ Do not touch the connector pins or soldered components on the circuit board in order to prevent possible Electrostatic Discharge (ESD) damage to the PCM.
^ In order to prevent internal damage to the PCM, the ignition must be OFF when disconnecting or reconnecting the PCM connector.




1. Install the PCM (1) to the mounting bracket (2).

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the PCM and mounting bracket assembly into the vehicle.

Tighten
Tighten the mounting bracket fasteners to 7 N.m (62 lb in).




3. Reconnect the PCM connectors.

Tighten
Tighten the PCM connector end fasteners to 8 N.m (70 lb in).

4. Connect the negative battery cable.
5. If a new PCM is being installed, program the PCM. Programming and Relearning