Knee Bolster Replacement - Left

REMOVAL PROCEDURE
1. Remove the rear compartment lid release switch, if equipped.
2. Remove the instrument panel (IP) knee bolster bolts.
3. Remove the IP knee bolster.

INSTALLATION PROCEDURE
1. Insert knee bolster tabs in IP.
2. Align knee bolster for best fit.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the IP knee bolster bolts.

Tighten
Tighten the IP knee bolster bolts to 2 N.m (18 lb in).

4. Install the rear compartment lid release switch, if equipped.