Fuel Tank Pressure Sensor: Service and Repair

REMOVAL PROCEDURE

Tools Required
^ J 34730-1A Fuel Pressure Gauge
^ J 42960-1 Fuel Tank Drain Hose
^ J 42960-2 Fuel Flapper Door Holder

CAUTION: Refer to the Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief Procedure. Service and Repair
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure. Procedures
4. Remove the fuel tank.
5. Disconnect the fuel pressure sensor electrical connector.
6. Remove the fuel pressure sensor (1).

INSTALLATION PROCEDURE
1. Install the fuel pressure sensor (1).
2. Connect the fuel pressure sensor electrical connector.
3. Install the fuel tank.
4. Refill the fuel tank.
5. Install the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks.
7.1. Turn the ignition switch ON for 2 seconds.
7.2. Turn the ignition switch OFF for 10 seconds.
7.3. Turn the ignition switch ON.
7.4. Check for fuel leaks.
8. Perform the idle learn procedure. Refer to PCM Idle Learn Procedure. PCM Idle Learn Procedure