Generator Replacement
REMOVAL PROCEDURECAUTION: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Remove the accessory drive belt.
3. Raise and suitably support the vehicle.
4. Remove the positive cable from the generator:
^ Slide the boot down revealing the positive terminal stud.
^ Remove the positive cable nut from the generator output stud.
^ Remove the positive cable.
5. Remove the generator rear bracket mounting bolt (1).
6. Remove the transmission oil cooler lines from the oil cooler clip.
7. Remove the front generator mounting bolts and oil cooler clip.
8. Disconnect the generator electrical connector (3).
9. Remove the generator from the vehicle.
INSTALLATION PROCEDURE
1. Install the generator to the vehicle.
2. Connect the generator electrical connector (3).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the front generator mounting bolts and oil cooler clip.
Tighten
Tighten the generator mounting bolts to 50 N.m (37 lb ft).
4. Install the transmission oil cooler lines to the oil cooler clip.
5. Install the generator rear bracket mounting bolt (1).
Tighten
Tighten the rear bracket mounting bolt (1) to 25 N.m (18 lb ft).
6. Install the positive cable to the generator:
^ Install the positive cable.
^ Install the positive cable nut to the generator output stud.
Tighten
Tighten the positive cable nut to the generator output stud to 22 N.m (16 lb ft).
^ Slide the boot over the positive terminal stud.
7. Lower the vehicle.
8. Install the accessory drive belt.
9. Connect the negative battery cable.