Hazard Warning Switch

Removal Procedure

Caution: Refer to SIR Handling Caution in Service Precautions.

Important: Do not remove the steering column in order to replace the hazard warning switch. Refer to Steering Column Replacement.





1. Remove the bolt/screw (4).
2. Remove the button (3).
3. Remove the spring (2).
4. Remove the knob (1).

Installation Procedure





1. Install the knob (1).
2. Install the spring (2).
3. Install the button (3).

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the bolt/screw (4).
- Tighten the bolt/screw to 0.7 Nm (6 inch lbs.).