Lock Housing - Assemble

Assembly Procedure





1. Lubricate the switch actuator pivot pin (2) with synthetic grease.
2. Install the switch actuator pivot pin (2) to the pivot and pulse dimmer switch assembly (1).
3. Install the pivot and pulse assembly (1) into the lock housing cover assembly.





4. Lubricate the dimmer switch rod actuator (3) with lithium grease.
5. Install the dimmer switch rod actuator (3) to the column housing cover end base plate (2).
6. Install the column housing cover end base plate (2) to the lock housing cover and sleeve assembly (1).

Important: The bottom edge of the dimmer switch rod actuator must rest on the bend of the dimmer switch rod.

7. Align the lock housing cover and sleeve assembly (1) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.





8. Install 3 pan head 6-lobe socket tapping screws: (1) at 12 o' clock position first, (3) at 8 o' clock position second, and (2) at 3 o'clock position third.
- Tighten the 3 pan head 6-lobed socket screws to 9 Nm (80 inch lbs.).





9. Mount the cruise control connector (3) on the base plate (1).
10. Install the column housing cover end cap (2).
11. Install the steering column lock cylinder set. Refer to Steering Column Lock Cylinder Set-Assemble-Off Vehicle.