Front

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement





3. Remove the stabilizer shaft insulator clamp bolts (4) and stud.
4. Remove the stabilizer shaft insulator clamps (5).
5. Remove the stabilizer shaft (7) from the vehicle.
6. Remove the insulators (6) from the stabilizer shaft (7), if necessary.

Installation Procedure

Important: The slit in the insulator (6) must face toward the front of the vehicle.





1. Install the stabilizer shaft insulators (6) over the stabilizer shaft (7), if necessary.
2. Place the stabilizer shaft (7) into position on the vehicle.
3. Install the stabilizer shaft insulator clamps (5) over the insulators.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the stabilizer shaft insulator clamp bolts (4) and stud.
- Tighten the stabilizer shaft insulator clamp bolts (4) and stud to 55 Nm (41 ft. lbs.).
5. Install the stabilizer shaft link. Refer to Stabilizer Shaft Link Replacement
6. Lower the vehicle.