Shift Control Knob Replacement
Removal Procedure1. Set the park brake.
2. Place the transmission control in neutral.
3. Unscrew the control lever knob (1).
Installation Procedure
1. Push the shift lever boot (2) down to access the lever threads.
Notice: Refer to Fastener Notice in Service Precautions.
2. Screw the shift control knob (1) onto the shift control lever.
^ Tighten the shift control knob to 3 Nm (27 inch lbs.).
3. Rotate the Hurst shift control knob (1) until the face is parallel to the instrument panel.
4. Place the transmission in gear.
5. Release the park brake.