Front (2 Door)

REMOVAL PROCEDURE
1. Remove the rubber boot (2) from the door-jamb switch (1).
2. Remove the screw which secures the switch (1) to the door jamb.
3. Perform the following steps in order to attain access to the electrical connector of the switch (1):
3.1. Remove the lower quarter trim finish panel.
3.2. Remove the rear radio speaker.
4. Disconnect the door-jamb switch electrical connector.
5. Remove the switch (1) from the vehicle.

INSTALLATION PROCEDURE
1. Connect the door-jamb switch electrical connector.
2. Install the door-jamb switch (1) to the vehicle. Secure the switch with the screw.
3. Perform the following steps:
3.1. Install the rear radio speaker.
3.2. Install the lower quarter trim finish panel.
4. Install the rubber boot (2) to the switch (1).