Front (4 Door)

REMOVAL PROCEDURE
1. Remove the rubber boot (2) from the door-jamb switch (1).
2. Remove the screw which secures the switch (1) to the door jamb.
3. Remove the lower center pillar trim panel in order to attain access to the electrical connector of the switch (1).
4. Disconnect the door-jamb switch electrical connector.
5. Remove the switch (1) from the vehicle.

INSTALLATION PROCEDURE
1. Connect the door jamb switch electrical connector.
2. Install the door-jamb switch (1) to the vehicle. Secure the switch with the screw.
3. Install the lower center pillar trim panel to the vehicle.
4. Install the rubber boot (2) to the switch (1).